28
GB
D:\NORM'S JOB\SONY HA\SO17_STR-DH190_PMRF1\STR-DH190 (PMRF
01)\4726907121_GB\070ADD.fm
masterpage: Left
STR-DH190
4-726-907-
12
(1)
• “BT POWER” (BLUETOOTH signal)
– “BT ON”: You can connect to the
receiver from a paired BLUETOOTH
device.
– “BT OFF”: The receiver cannot be
connected from a paired BLUETOOTH
device.
You cannot change this setting when
“BLUETOOTH” input is selected.
“PH.OFFSET” (Phono volume
offset)
Lets you adjust the volume level of the
device connected to PHONO IN jacks.
MM type cartridge used on turntable have
a variation of audio output level.
In case MM type cartridge output is small,
you can use phono volume offset to
increase the level.
You can adjust from 0 dB to +6 dB in
1 dB/step.
The initial setting is “PHONO 0”.
“BALANCE” (Speaker balance)
Lets you adjust the balance between left
and right speakers.
You can adjust from “BAL. L+10” to
“BAL. R+10” in 1 dB/step.
The initial setting is “BAL. 0”.
“NAME IN” (Naming inputs)
Lets you set the name of inputs and preset
stations. For details, see “Changing the
Name for Each Input and Preset Station
(NAME IN)” (page 29).
“AUTO.STBY” (Auto standby)
Lets you set the receiver switch to standby
mode automatically when you do not
operate the receiver or when there is no
signals input to the receiver.
• “STBY ON”
Switches to standby mode after
approximately 20 minutes.
• “STBY OFF”
Does not switch to standby mode.
• This function does not work when “FM TUNER”
input is selected.
• If you use the Auto Standby mode and the Sleep
Timer at the same time, the Sleep Timer has
priority.
“UPDATE” (Software update)
For service purpose only.
“VERSION” (Software version)
Lets you check the system’s software
version information.
Note
Note
