Gettin
g
Star
ted
masterpage:Right
lename[E:\SEM_Janet\Revision
Data\J9050000_2580805131DA2100ES_US\2580805131\US03CON_STR-DA2100ES-U.fm]
21
US
model name1[STR-DA2100ES]
[2-580-805-
12
(1)]
Tip
The receiver lets you to input the speaker position in
terms of distance. However, it is not possible to set the
center speaker further than the front speakers. Also, the
center speaker cannot be set more than 5 feet closer
than the front speakers.
Likewise, the surround speakers and the surround back
speakers cannot be set further away from the listening
position than the front speakers. And they can be no
more than 15 feet closer.
This is because incorrect speaker placement is not
conducive to the enjoyment of surround sound.
Please note that, setting the speaker distance closer than
the actual location of the speakers will cause a delay in
the output of the sound from that speaker. In other
words, the speaker will sound like it is further away.
For example, setting the center speaker distance 3–6
feet closer than the actual speaker position will create
a fairly realistic sensation of being “inside” the screen.
If you cannot obtain a satisfactory surround effect
because the surround speakers are too close, setting the
surround speaker distance closer (shorter) than the
actual distance will create a larger sound stage.
Adjusting these parameter while listening to the sound
often results in much better surround sound. Give it a
try!
Adjust the speaker levels and balance while
listening to the test tone from your listening
position. Use the remote for the operation.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
1
Press
?/1
to turn on the receiver.
2
Press TEST TONE.
“T. TONE XXXXXX” appears in the
display and the test tone is output from each
speaker in sequence.
Front left (L)
t
Center (C)
t
Front right
(R)
t
Surround right (SR)
t
Surround
back right (SBR)*
t
Surround back left
(SBL)*
t
Surround left (SL)
t
Sub
woofer (SW)
* You will only hear the test tone from the
– surround back left (SBL) and surround back
right (SBR) speakers when the surround
back speakers selection parameter is set to
“DUAL”.
– surround back (SB) speaker when the
surround back speakers selection parameter
is set to “SINGLE”.
3
Adjust the speaker levels and balance
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
For details on the LEVEL menu settings,
see page 37.
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/– on the remote or
turn MASTER VOLUME –/+ on the receiver.
• The adjusted value are shown in the display
during adjustment.
4
Press TEST TONE again after
adjustment.
The test tone turns off.
6: Adjusting the speaker
levels and balance
— TEST TONE
continued
US01COV_STR-DA2100ES-U.book Page 21 Wednesday, July 13, 2005 2:17 PM
