![background image](http://html.mh-extra.com/html/sony/ss-v521/ss-v521_operating-instructions_419764001.webp)
E
e
SURROUND BACK
Ee
English
Hooking up the speaker (
A
)
Connect the speaker to the speaker output terminals of
an amplifier.
Make sure power to all components (included the
subwoofer) is turned off before starting the hook-up.
Notes (
B
)
• Make sure the plus (+) and the minus (–) terminals on
the speakers are matched to the corresponding plus (+)
and minus (–) terminals on the amplifier.
• Be sure to tighten the screws of the speaker terminals
securely as loose screws may become a source of noise.
• Make sure all connections are firm. Contact between
bare speaker wires at the speaker terminals may cause
a short-circuit.
• For details regarding the connections on the amplifier
side, refer to the manual that was provided with your
amplifier.
Tip
All striped wires are minus (–) in polarity, and should be
connected to the minus (–) speaker terminals.
A
E
e
E
e
E
e
E
e
B
Micro Satellite Speaker
SS-V811ED/V521
Surround back
Foot pads
D
1
3
4
2
C
2001 Sony Corporation
Printed in China
Specifications
SS-V811ED (SS-MS815)
Speaker system
2 way, magnetically
shielded
Speaker units
Tweeter: 1.9 cm (
3
/
4
in.),
dome type
Woofer: 5 cm (2 in.)
×
2,
balanced drive type
Enclosure type
Bass reflex
Rated impedance
8 ohms
Power handling capacity
Maximum input power:
140 W
Sensitivity level
87 dB (1 W, 1 m)
Frequency range
120 Hz - 70,000 Hz
Dimensions (w/h/d)
When attached speaker grille:
Approx. 86
×
169
×
130
mm
(3
1
/
2
×
6
3
/
4
×
5
1
/
8
in.)
When attached to supplied speaker stand:
Approx. 96
×
207
×
141
mm
(3
7
/
8
×
8
1
/
4
×
5
5
/
8
in.)
Mass
When attached speaker grille:
Approx. 1.3 kg
(2 lb 14 oz)
When attached to supplied speaker stand:
Approx. 1.4 kg
(3 lb 1 oz)
SS-V521 (SS-MS525)
Speaker system
Full range
×
2,
magnetically shielded
Speaker units
5 cm (2 in.), balance
drive
type
Enclosure type
Bass reflex
Rated impedance
8 ohms
Power handling capacity
Maximum input power:
120 watts
Sensitivity level
87 dB (1 W, 1 m)
Frequency range
120 Hz - 20,000 Hz
Dimensions (w/h/d)
Approx. 89
×
144
×
130 mm
(3
5
/
8
×
5
3
/
4
×
5
1
/
8
in.),
including front grille
Mass
Approx. 750 g
(1 lb 10 oz)
Positioning the speakers
Location of each speaker
Tips
• Movies are best enjoyed in a room that produces no
echoes (as in one with surrounding curtains).
• Music (especially classical music) is best enjoyed in a
room that produces some echo.
Positioning the speaker
(for SS-V811ED only) (
C
)
Attach the speaker to supplied speaker stand and place
them at their optimum locations.
For details on the location of the speaker, see “Location
of each speaker”.
1
Detach the plate from the stand.
2
Pass the speaker cord into the hole on the
back of the stand and out from the hole at the
center of the stand.
3
Separate the speaker cord, then secure the
cord to the speaker stand with the plate.
4
Connect the speaker cord to the speaker
terminal.
The cord should be pressed into the groove
in the stand.
5
Using the supplied screws and washers,
secure the speaker to the stand.
Note
Do not remove the supplied speaker grille from the
speaker while attaching the speaker to the speaker stand.
Setting the speaker
(for SS-V521 only) (
D
)
To prevent speaker vibration or movement while
listening, attach the supplied foot pads to the speaker.
Precautions
On operation
• Do not drive the speaker system with a continuous
wattage exceeding the maximum input power of the
system.
• If the polarity of the speaker connections are not
correct, the bass tones will be weak and the position of
the various instruments obscure.
• Contact between bare speaker wires at the speaker
terminals may result in a short-circuit.
• Before connecting, turn off the amplifier to avoid
damaging the speaker system.
If you encounter color irregularity on a
nearby TV screen
This speaker system is magnetically shielded to allow it
to be installed near a TV set. However, color
irregularities may still be observed on certain types of TV
sets.
If color irregularity is observed...
c
Turn off the TV set once, then turn it on again after
15 to 30 minutes.
If color irregularity is observed again...
c
Place the speakers further away from the TV set.
If howling occurs
Reposition the speakers or turn down the volume on the
amplifier.
On placement
• Do not set the speakers in an inclined position.
• Do not place the speakers in locations that are:
—
Extremely hot or cold
—
Dusty or dirty
—
Very humid
—
Subject to vibrations
—
Subject to direct sunlight
On cleaning
Clean the speaker cabinets with a soft cloth lightly
moistened with a mild detergent solution or water. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
If you have any questions or problems concerning your
speaker system, please consult your nearest Sony dealer.
Amplifier
4-233-678-11(1)
Front (Right)
Subwoofer
Rear(Right)
Front (Left)
Rear (Left)
Center
Surround back
5
Features
The instructions in this manual are for SS-V811ED and
SS-V521, Sony Micro Satellite Speaker.
If you add this speaker to SA-VE815ED and SA-VE525,
you can enjoy the surround effect as a 6.1 channel
speaker system. Please refer to the manual provided for
SA-VE815ED and SA-VE525 when you connect this
speaker to the other speakers of SA-VE815ED and SA-
VE525.
Any difference in operation is clearly indicated in the
text, for example, “SS-V811ED only”.
Supplied accessories
Speaker stand (1) (SS-V811ED only)
Screws (2) (SS-V811ED only)
Washers (2) (SS-V811ED only)
Plate (1) (SS-V811ED only)
Foot pads (4) (SS-V521 only)
Speaker connecting cords, 10 m (32 ft 9
3
/
4
in.) (1)
Design and specifications are subject to change without
notice.