Sony SRX-R210, Operating Instructions Manual

Page: 24 / 28

24
Messages
FAILURE: Danger level – Low
Information Messages
The message number is not displayed for information messages. Check the following if a message appears in the STATUS
MESSAGE window.
WARN_22 DEVICE ERROR Failure of the peltier B control
WARN_23 CONNECTOR DETACHED The peltier R connector disconnected
WARN_24 CONNECTOR DETACHED The peltier G connector disconnected
WARN_25 CONNECTOR DETACHED The peltier B connector disconnected
WARN_26 DOUSER ERROR Trouble with the douser operation
WARN_27 BALLAST ERROR Failure of the ballast communication for the lamp power
WARN_28 BALLAST ERROR Incorrect settings of the lamp S/N or the lamp power wattage
Message number Error message Meaning
Message number Error message Meaning
FAIL_01 TEMPERATURE ERROR Temperature of the system area is too high.
FAIL_02 TEMPERATURE ERROR Temperature of the projector head area is too high.
FAIL_03 TEMPERATURE ERROR Temperature of the power area is too high.
FAIL_04 TEMPERATURE ERROR Temperature of the intakes is too high.
FAIL_06 TEMPERATURE ERROR Temperature of the optical unit area is too high.
FAIL_10 TEMPERATURE ERROR Warning for abnormal temperature of Panel R
FAIL_11 TEMPERATURE ERROR Warning for abnormal temperature of Panel G
FAIL_12 TEMPERATURE ERROR Warning for abnormal temperature of Panel B
FAIL_13 TEMPERATURE ERROR Warning for abnormal temperature of the lamp
FAIL_15 TEMPERATURE ERROR Warning for abnormal temperature of the lamp power
FAIL_16 LENS ERROR Failure of the zoom position adjustment to the registered setting
FAIL_17 LENS ERROR Failure of the lens focus adjustment to the registered setting
FAIL_18 LENS ERROR Trouble with the zoom position adjustment
FAIL_19 LENS ERROR Trouble with the lens focus adjustment
FAIL_21 ADJUSTMENT ERROR Abnormal in the Z-axis adjustment
FAIL_24 ADJUSTMENT ERROR Failure of calibration for luminance deterioration
FAIL_25 DEVICE ERROR Failure of FPGA configuration
FAIL_26 DEVICE ERROR Trouble with the IIC circuit
FAIL_27 DEVICE ERROR Trouble with the LVDS circuit
FAIL_28 DEVICE ERROR Trouble with the PLL circuit
FAIL_29 DEVICE ERROR Trouble with the PARITY circuit
FAIL_30 BALLAST ERROR Lamp power interlocked
FAIL_34 ADJUSTMENT ERROR Deviation of the Z-axis operation for + direction
FAIL_35 ADJUSTMENT ERROR Deviation of the Z-axis operation for – direction
FAIL_36 DEVICE ERROR Error of the DVI setting
Message Meaning
DOUSER CLOSED Douser is closed.
LAMP POWER + LIMIT Lamp power was automatically adjusted by correcting luminance
deterioration, but the picture is not brighter.