71
Troubleshooting
A
ppe
ndix
Network access
When using a network cable to access the files in
SRMemory cards, you can access the files if other
recording or playback is in process. However, since SDI
input/output has priority, the transfer rate via the network
may decrease depending on input/output port usage.
Troubleshooting
Salvaging SRMemory Card in the
Event Recording does not End
Normally
After recording is completed, press the Eject button to
safely eject the SRMemory card, or press the On/Standby
button on the front panel to end unit operation. Recording
will not end normally if the main power switch of the
connector panel is turned off or the power cord is
disconnected during recording. If this happens, the file
system will not be updated and the video/audio data that
was recorded in real time will not be recognized as a file,
resulting in the content of the file that was recorded being
lost.
The unit is equipped with a function (salvage function) for
restoring the data in SRMemory card with minimal loss.
The salvage function allows the file to be restored based on
the marker and other information recorded to the
SRMemory card.
The salvage process takes a few seconds to up to 60
minutes, depending on the state of the SRMemory card
when the recording was interrupted.
• Before turning off the main power switch on the
connector panel, switch the unit to the standby state with
the On/Standby button on the front panel.
• The salvage function is designed to salvage as much
recorded material as possible in the event that an
unforeseen accident occurs but there is no guarantee that
100% of the data will be restored.
• The data immediately before recording was interrupted
cannot be restored even if you execute this function. The
amount of data that is lost is as follows.
In SR-Lite mode:
approx. 8 seconds of the data
In SR-SQ mode:
approx. 4 seconds of the data
In SR-HQ mode:
approx. 2 seconds of the data
• Each time you insert an SRMemory card containing a
file that has not been restored or turn the power on with
such card in the unit, a confirmation dialog will appear
asking you whether to perform a salvage.
• An SRMemory card containing a file that has not been
restored cannot be used to play back or record.
• Formatting the SRMemory card will enable you to use it
again, but all recorded data will then be lost.
Only S55
cards
1 to 3
SR-Lite (2D/3D), SR-SQ (2D/
3D), SR-HQ (2D/3D)
The cards must be inserted in
slots 1 to 3.
4
SR-Lite (2D/3D), SR-SQ (2D/
3D), SR-HQ (2D)
Cards in any of the slots (one
or more) can be used.
Types of
cards used
Number of
simultaneous
recordings
Recordable data formats
Notes
