A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the Network — Network setting Menu
28
Wireless network Tab (SNC-M3W
only)
Use this to set connection for the wireless network.
SSID
Type the ID to identify the wireless network you want to
access using up to 32 ASCII characters (alphanumeric).
For your security, be sure to change the factory setting.
Type
Select the network connection type
Adhoc mode
or
Infrastructure mode
. Select
Adhoc mode
when
connecting to the computer directly, or select
Infrastructure mode
when connecting to the computer
via an access point or a radio router. When you select
Ad
hoc mode
, specify the wireless channel.
Channel
Set the channel when making adhoc connection is set up.
Tip
Set the channel of the computer and a camera at the
same value.
Note
For better wireless communication, check for the
channel used by the operating network and select the
channel that is used less.
WEP
Select
On
when you use the WEP (Wired Equivalent
Privacy) keys, or
Off
when you do not use it.
The WEP key data settings are valid only when the WEP
menu is set to
On
.
WEP key data
Specify up to 4 WEP keys. The length of a WEP key is
40 or 104 bit. A 104-bit WEP key has a higher security
level than a 40-bit key. You can type the WEP key either
in hexadecimal numbers (0 to 9 and A to F) or ASCII
characters (alphanumeric).
When the Type menu is set to
Infrastructure mode
, the
WEP key should be the same as that of the access point.
When the Type menu is set to
Ad hoc mode
, the WEP
key should be the same as that of the communication
client.
Notes
• To activate the wireless connection, unplug the
network cable and turn on the camera.
• The wireless connection and the wired connection
using the network cable cannot be used
simultaneously.
Dynamic IP address notification
Tab — Notifying the IP Address
When the DHCP setting is set to
On
on the Network tab,
you can send notification of the completion of the
network settings using the SMTP or HTTP protocol.
e-mail (SMTP) notification
Select
On
to send an E-mail when the DHCP setting is
completed.
SMTP server name
Type the name or IP address of the SMTP server you
want to use for sending an E-mail, up to 64 characters.
Authentication
Select the authentication required when you send an e-
Mail.
None:
Select when no authentication is necessary when
an e-mail is sent.
SMTP authentication:
Select when authentication is
necessary when an e-mail is sent.
POP before SMTP:
Select when
POP before SMTP
is
necessary when an e-mail is sent.
