26
Setting the Set-Top Box
Notes
• If your VCR is connected to the STB by the aerial cable, enter the programme
number of the VCR corresponding to the channel where you have set up the STB
output in step 4.
• You cannot watch programmes from your STB on the TV while recording unless
you record a programme from your STB.
• It is recommended to connect your STB to the DECODEUR/ENTREE LIGNE-3
connector.
• For some STB, in order to avoid any conflict between the STB controller and the
VCR remote commander, be careful not to point the remote commander towards
the STB and the VCR at the same time.
• If VEILLE ECO is set to TOTAL, you cannot watch or record programmes from
your STB during standby mode. Set VEILLE ECO in the OPTIONS-2 menu to
NON or PARTIELLE.
4
• If you connect the STB using the
aerial cable:
Press
M
/
m
/
,
to select RF and
press OK.
Press
M
/
m
to highlight
N° CHAÎNE and press OK. Enter
the appropriate number using
M
/
m
and press OK.
• If you connect the STB using the
PERITEL cable:
Press
M
/
m
/
,
to select LIGNE3
and press OK.
5
Press
M
/
m
to highlight N° CODE
MARQUE STB and press OK. Enter
the appropriate number using the
programme number buttons, then
press OK. Refer to the table on page
27 for Set-Top Box brand number.
Press MENU to exit the menu.
OK
LECTURE
SET-TOP BOX
RF
---
06
CONNEX. STB
N˚ CODE MARQUE STB
N˚ CHAÎNE
RETOUR
MENU
:
:
:
OK
REGLER
SELECTIONNER
SORTIE
SET-TOP BOX
LIGNE3
---
CONNEX. STB
N˚ CODE MARQUE STB
RETOUR
MENU
:
:
:
OK
REGLER
SELECTIONNER
SORTIE
MENU
OK
LECTURE
1
2
3
4
5
6
7
8
9
0
SET-TOP BOX
RF
123
06
CONNEX. STB
N˚ CODE MARQUE STB
N˚ CHAÎNE
RETOUR
MENU
:
:
:
OK
REGLER
SELECTIONNER
SORTIE
