Sony SFD-FW200P, Operating Instructions Manual

Page: 21 / 100

21
Additional Information
Maintenance, cleaning the case
The HiFD drive case may be cleaned with a soft cloth slightly
moistened with water or a mild detergent. Never use any type
of abrasive pad, scouring powder or solvent.
Troubleshooting
Should a problem or difficulty occur, please consult the
Internet at http://www.sony-cp.com/hifd or the following
table before contacting Sony’s Hotline Support.
Problem Cause/Solution
The POWER or BUSY
lamp does not light when
power is on.
The HiFD drive is not
recognized by the PC, or
it does not operate
correctly.
The HiFD drive unit or
AC power adapter
become warm.
Confirm that the AC power adapter is
connected correctly.
The AC power adapter’s protection circuit
may have tripped: try unplugging it, waiting
a few minites, and plugging it back in.
The driver may not be installed.
The interface cable may not be connected
correctly.
An interface cable connector pin may be
bent or broken.
Not necessarily a malfunction (if they
become very hot, unplug the AC power
adapter and contact the Technical Support
Center)