75
Theater Setup
C
h
ap
te
r 2
T
h
ea
te
r S
e
tu
p
an
d
S
y
s
tem
Se
c
u
rity
The Lamp Install “wizard” (initial screen shown below)
begins the process of entering the Lamp Serial code for the
new (replacement) lamp.
To proceed to Serial Code entry click
Next
.
The Lamp Serial Code is included with the replacement
(new) lamp. To enter the Lamp Serial Code tap the text
box. An on-screen numeric keyboard appears.
Using the on-screen keyboard, tap the numeric
Serial
Code
and then tap
Enter
. The Serial Code is validated for
correct format and Next becomes available. Tap
Next
to
continue to Lamp Axis Adjust.
To cancel Serial Code entry, if any entry has been made
into the Serial Code text box tap
Clr
, then tap
Enter
, and
then tap
Cancel
. If no entry has been made into the Serial
Code text box simply tap
Enter
and then tap
Cancel
. In
either case, a popup confirmation appears. Tap
Yes
and the
Lamp Install Wizard closes.
The lamp should be replaced prior to exceeding
recommended operating hours. Refer to the projector
documentation for additional information.
Lamp Axis Adjust
The Lamp Axis Adjust entry feature has been made
available under the “trsetup” login and combined with
other functions, i.e., Lamp Serial Code entry and Image
Registration
1
. Previously, Lamp Axis Adjust required
using the SRX Controller application.
• Lamp Axis Adjust is only available through the
pre-defined Theater Setup login thus insuring that this
adjustment is only done by qualified personnel.
• If power to the projector is turned off during Lamp Axis
Adjust, restart the SMS.
Adjust X, Y, & Z Lamp Axis
Installation of a new lamp is a multistep process and once
the lamp is installed the Lamp Axis (X, Y, and Z) must be
adjusted for optimum light output.
Normally, the Lamp
Axis Adjust process is
performed following
Lamp Installation and
setting the Lamp Serial
Code. In this case the
Lamp Install wizard will
automatically progress
from Serial Code entry
to Axis Adjust.
However, if the axis
adjustment cannot be
performed at the time of
installation you can
directly access the Lamp
Axis Adjust steps using
the “trsetup” login.
The Wizard automatically checks for the correct Projector
Power mode of operation, e.g., Lamp Axis Adjust requires
LAMP ON mode. For Lamp Axis adjustment the Lamp
should be on for an amount of time (approximately 5
minutes) to insure stability of the lamp output. A
countdown timer has been included to indicate how much
time remains before axis adjustment can begin.
Caution
Cancel
Next
Next
Serial Code Text Box
Cancel
1.In previous versions, Image Registration required use of
the SRX Controller application.
Caution
Tap Menu
Tap Projector
Tap Lamp Axis Adjust
Summary of Contents for Screen Management System
Page 81: ...Sony Corporation ...
