Sony SAL16105 - Zoom Lens - 16 mm, Service Manual

Page: 5 / 164

2-1
SAL16105 (DT 3.5-5.6/16-105) (DT 16-105mm F3.5-5.6)
2. DISASSEMBLY
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Notches Holes
Universal wrench
J-6082-609-A
Chip-A for
universal wrench:
J-6082-609-1 Chip-B for
universal wrench:
J-6082-609-2
Notches
Chip-A
Chip-A
Chip-B
Chip-B
Chip
Chip
Match the universal wrench
to the width of holes or notches.
Universal wrench
Holes
A-20
B-110
B-40
G-118
O-20
B-10
G-115
G-116
LOCTITE 460
or the equivalent
SERVICE TOOLS
Anti-diffusion agent (A-20): J-6082-611-A
Adhesive bond (B-110): J-6082-617-A
Adhesive bond (B-40): J-6082-614-A
Grease (G-118): J-6082-680-A
Oil (O-20): J-6082-610-A
Adhesive bond (B-10): J-6082-612-A
Grease (G-115): J-6082-627-A
Grease (G-116): J-6082-628-A
Adhesive bond (LOCTITE 460)
or the equivalent.
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, dont’ pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, dont’ press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
UNIVERSAL WRENCH
In case of the following notches or holes are located in the lens block, etc during disassembling/
assembling the lens, Use the universal wrench.
How to Use
Attach the chip-A or chip-B to the universal wrench.
For the notches: chip-A
For the holes:
chip-B
Match the universal wrench to the holes or notches of the lens block, etc.