Note
Register cameras before connection standby mode of this unit is canceled.
The multi camera control function is only available with the compatible cameras.
When operating a camera that does not support the multi camera control function, set the connection
mode to
(Single connection).
You cannot copy images recorded in the camera to this unit.
The WPS method is used for connecting the Live-View Remote to multiple cameras. If there is
another device using the WPS method in the vicinity of the cameras, the registration may fail. If the
registration fails, reconnect by performing each step again.
[11] How to use
Getting Started
Connecting this unit to multiple cameras via Wi-Fi
(Multi connection)
Resetting the connection information of the registered
camera
This function is only available when the camera is in multi connection.
1. Press the MENU button.
The list of setting items is displayed.
2. Press the UP button or DOWN button to select
(Remote control settings) -
(Reset
network settings) and press the REC/ENTER button.
3. Press the UP button or DOWN button to select
or
(Cancel) and press the REC/ENTER
button.
[12] How to use
Shooting
Shooting movies and still images
Switching shooting modes
Switch the shooting mode by pressing the UP/DOWN button on the Live-View display of this unit during
single connection.
Some shooting modes cannot be set depending on the connected camera. Refer to the instruction
manual of the connected camera.
The shooting mode icon is displayed on the upper left side of the display.
