Sony RDR-HX780, Operating Instructions Manual

Page: 22 / 136

22
B
Audio L/R (left/right) input jacks
This connection will use your TV’s or audio
component’s two speakers for sound.
z Hint
For correct speaker location, refer to the operating
instructions supplied with the connected
components.
b
Notes
• Do not connect your TV’s audio output jacks to
the LINE IN (R-AUDIO-L) jacks at the same
time. This will cause unwanted noise to come
from your TV’s speakers.
• With connection B , do not connect the LINE IN
(R-AUDIO-L) and LINE OUT (R-AUDIO-L)
jacks to your TV’s audio output jacks at the same
time. This will cause unwanted noise to come
from your TV’s speakers.
• With connection
A
, after you have completed
the connection, make the appropriate settings in
the “Audio Out” setup (page 102). Otherwise, no
sound or a loud noise will come from your
speakers.
• When you connect the recorder to an audio
component using an HDMI cord, you will need
to do one of the following:
– Connect the audio component to the TV with
the HDMI cord, or
– Connect the recorder to the TV with a video
cord other than HDMI cord (component video
cord, S-video cord, or audio/video cord).
Step 4: Connecting the
AC Power Cord
Connect the supplied AC power cord to the
AC IN terminal of the recorder. Then plug
the recorder and TV power cords into the AC
outlet. After you connect the AC power
cord,
you must wait for a short while
before operating the recorder. You can
operate the recorder once the front panel
display lights up and the recorder enters
standby mode.
If you connect additional equipment to this
recorder (page 27), be sure to connect the
AC power cord after all connections are
complete.
*1
*2
to AC outlet
to AC IN
1
2