110
Input Line System
Selects the colour system when recording
from the connected equipment.
b
Notes
• When picture noise appears after you change the
“Input Line System” setting, change the “Input
Colour System” setting (page 113). If picture
noise still appears, hold down
x
(stop) on the
recorder, and press INPUT on the recorder.
• When you change the “Input Line System”
setting, the Dubbing List is erased.
Power Save
Selects whether this recorder is in power save
mode when the power is turned off (standby).
b
Note
Power Save mode does not function in the
following cases, even when “Power Save” is set to
“Mode 1” or “Mode 2.”
– There is a timer setting with “VPS / PDC” in the
SCHEDULE list.
– The SMARTLINK features are not available
when “Power Save” is set to “Mode 1” or “Mode
2.”
HELP Setting
Easy Setup (Resetting the Recorder)
Select this to run the “Easy Setup”
programme.
1
Select “Easy Setup” in “Basic,” and press
ENTER.
2
Select “Start,” and press ENTER.
3
Follow the instructions for “Easy Setup”
(page 23) from step 2.
NTSC
Records in NTSC or PAL-60
colour system.
PAL/
SECAM
Records in PAL or SECAM
colour system.
Mode 1
Only antenna input signals are
output to the connected TV
when the recorder is in standby.
Mode 2
No input signals are output
when the recorder is in standby.
Off
Does not set to power save
mode. Normally, select this
setting.
On
Displays Help information for
GUI displays.
Off
Does not set to HELP setting
mode.