37
2-6-2. SE-1187 Board, Lens (LSV-1740B), Prism Assembly (LSV-1620)
Preparation
1. Remove the outside panel assembly. (Refer to
“
2-2. Outside Panel Assembly
”
.)
2. Remove the CT-287A board. (Refer to “2-3. CT-287A Board”.)
3. Remove the VC-41 board. (Refer to “2-4. VC-41 Board”.)
4. Remove the DC fan. (Refer to “2-5. DC Fan”.)
5. Remove the lens assembly. (Refer to “2-6-1. LD-136 Board, Lens Assembly”.)
Procedure
1. Remove the two precision screws, and then remove the lens cabinet assembly.
Install the lens cabinet assembly as follows.
・
Tighten the precision screws in the following sequence: (a), (b).
・
Pass the fine-wire coaxial cable (green) and the fine-wire coaxial cable (blue) through the hole of the lens cabinet assembly.
(a)
(b)
Lens cabinet assembly
Hole
Precision screws
(TP2 x 5)
Fine-wire coaxial cable (green)
Fine-wire coaxial cable (blue)
Note