Sony PXW-Z150 XDCAM, Operating Manual

Page: 22 / 152

22
On the battery pack
• Always turn the ON/STANDBY switch to
STANDBY ( 1 ) before changing the battery
pack.
• The CHG lamp flashes during charging, or the
Battery Info will not be correctly displayed
under the following conditions.
– The battery pack is not attached correctly.
– The battery pack is damaged.
– The battery pack is worn-out.
Using a power outlet
You can use the AC Adaptor to obtain the
AC power. While you are using the AC
Adaptor, the battery pack will not lose its
charge even when it is attached to your
camcorder.
Perform the procedure up to step 3 of “Step
2: Charging the battery pack” (p. 20).
On the AC Adaptor
• Do not short-circuit the DC plug of the AC
Adaptor or battery terminal with any metallic
objects. This may cause a malfunction.
Step 3: Attaching the
accessory shoe
To mount the accessory shoe
Mount the accessory shoe on the accessory
shoe mount as illustrated.
1
Lift the edge of the accessory shoe plate
and pull it in the direction opposite to
that of the arrow on the accessory shoe
plate and remove it from the accessory
shoe.
2
Place the accessory shoe as its
protrusions matches recesses of the
accessory shoe mount, then fix it to the
mount with four screws.
3 Insert the accessory shoe plate in the
direction of the arrow on the plate
surface until the end of the plate
engages the end of the shoe.
To remove the accessory shoe
Remove the shoe plate in the same way as
step
1 of “To mount the accessory shoe.”
Loosen the 4 screws and remove the
accessory shoe from the accessory shoe
mount.
Accessory shoe plate
Accessory shoe
Accessory
shoe
Accessory shoe plate
Step 2: Charging the battery pack
(Continued)