Sony PXW-X200, Operating Instructions Manual

Page: 82 / 180

Clip Operations 82
P
la
y
bac
k
In Normal playback mode, you can monitor the
recorded audio signals through the built-in
speaker
(page 9) or connected headphones.
With the headphones connected to the headphone
connector
(page 8) , the built-in speaker is turned
off.
Press the VOLUME buttons
(page 10) to adjust
the sound volume.
You can select audio channel(s) to be monitored
with “Audio Output”
(page 105) of the AUDIO
SET menu.
To start playback from the top of the first clip
Press the PREV button and F REV button
simultaneously. The top of the first-recorded clip
on the memory card is cued up.
To start playback from the top of the last clip
Press the F FWD button and NEXT button
simultaneously. The top of the last-recorded clip
on the memory card is cued up.
In the same manner as in recording, you can add
shot marks to the clip during playback.
At the point where you wish to add a shot
mark, press the “Shot Mark1” or “Shot
Mark2” assigned button.
Notes
• No shot mark can be added if the memory card is write-
protected.
• No shot mark can be added to the first or last frame of
a clip.
During thumbnail screen playback, etc., you can
operate the clips or confirm and change the
subsidiary data for clips using the Clip Operation
menus. The corresponding Clip Operation menu
pops up on the screens as shown below when you
press the SEL/SET button or the jog dial.
Monitoring Audio
Cueing Up
Adding Shot Marks During
Playback (UDF, exFAT, and FAT HD
Mode)
Clip Operations
Clip Operation Menus
Thumbnail screen (page 83)
CANCEL
DISP CLIP INFO
OK MARK ADD (FAT only)
OK MARK DELETE (FAT only)
OK FLAG ADD (UDF and exFAT)
NG FLAG ADD (UDF and exFAT)
KEEP FLAG ADD (UDF and exFAT)
CLIP FLAG DELETE (UDF and exFAT)
LOCK CLIP (UDF and exFAT)
UNLOCK CLIP (UDF and exFAT)
COPY CLIP
DELETE CLIP
ALL MARKS
SHOT MARK1
SHOT MARK2
REC START MARK (UDF and exFAT)
EXPAND CLIP