Sony PXW-X200, Operating Instructions Manual

Page: 81 / 180

Playing Clips 81
P
la
y
bac
k
For playback operations, use the playback control
buttons on the handle
(page 10) . When the IR
Remote Commander is enabled, you can use its
playback control buttons instead
(page 21) .
1
Using the up/down/left/right buttons or
the jog dial, move the cursor to the
thumbnail image of the clip with which
you wish to start playback.
2
Press the PLAY/PAUSE button.
Playback starts from the beginning of the
selected clip.
Notes
• The playback picture may be momentarily distorted or
frozen between clips. The playback control buttons
and THUMBNAIL button do not function during this
condition.
• When you select a clip on the thumbnail screen and
start playback, the playback picture at the beginning of
the clip may be distorted. To start playback without
distortion, once pause playback after starting it, press
the PREV button to return to the top of the clip, then
restart playback.
Information displayed on the playback
screen
The following information is superimposed on
the playback picture.
1.
Battery remaining/DC IN voltage
2.
Playback mode
3.
SxS memory card
A mark appears to the left if the SxS memory
card is write-protected.
4.
Time data
The time data for the playback picture are
displayed. Each time you press the
DURATION/TC/U-BIT button, the indication
is switched between timecode (TCR) and user-
bit (UB) data.
5.
Clip no./total number of clips
This is displayed for FAT. It is also displayed
for UDF and exFAT if “Find Mode” in “Clip”
(page 122) of the OTHERS menu is set to
“Clip.”
6.
Clip no./total number of clips, essence
mark no./total number of essence marks
This is displayed for UDF and exFAT if “Find
Mode” in “Clip”
(page 122) of the OTHERS
menu is set to “Rec Start.”
7.
Audio levels
The audio levels for the recording are displayed.
Playing Clips
Playing the Selected and
Subsequent Clips in Sequence
TCR 00:00:00:00
0011/0 3 00
120min
B
PLAY
CH1
CH2
1 2 3 4 5
7