113
HDMI output settings for HDMI devices
Notes
• If the current Output Display setting becomes unavailable for selection after changing HDMI Target Device, the Output
Display setting changes as follows.
– Forcibly changes to the default value.
– If the default value is not available for selection, forcibly changes to “SDI=On, HDMI=On.”
• HDMI Target Device cannot be set to Recorder if Codec is set to ProRes.
States When Monitor LUT Cannot be Configured Independently
In the following cases, Monitor LUT >SDI2, HDMI, and Viewfinder in the Video menu cannot be set
individually. They are synced with the SDI1 & Internal Rec setting.
– When Output Format >HDMI in the Video menu is set to 4096×2160 or 3840×2160
– When S&Q Motion >Setting in the Recording menu is set to On
– When Lens >Distortion Comp. in the System menu is set to Auto
States When Video Signal Monitor Cannot be Displayed
• To use Video Signal Monitor, SDI output must be enabled. Also, the output resolution must be 2K or
lower. Check the following settings.
– Output On/Off >SDI in the Video menu
– Output Format >SDI in the Video menu
• In the following cases, Video Signal Monitor cannot be displayed in the viewfinder.
– When the SDI output is edge cropped using Output Setting >4K/2K to HD Conv. in the Video menu
– When there is a mixture of MLUT On and MLUT Off settings for Monitor LUT >SDI1 & Internal
Rec, SDI2, HDMI, and Viewfinder in the Video menu
Output Setting >HDMI Target
Device in the Video menu
Output Display >SDI/HDMI in
the Video menu
HDMI output
OSD On/Off
MLUT On/Off
Recorder (default)
SDI=On, HDMI=On (default)
* Grayed out, cannot be selected.
–
Follows SDI1
SDI=On, HDMI=Off
Off
SDI=Off, HDMI=Off
Off
Monitor
SDI=On, HDMI=On (default)
On
Follows SDI2
SDI=On, HDMI=Off
* Grayed out, cannot be selected.
–
SDI=Off, HDMI=Off
Off
Summary of Contents for PXW-FS7
Page 128: ......
