Sony PXW-FS5, Operating Manual

Page: 156 / 200

156
Sets the CH-2 audio source.
B INT MIC
Internal microphone.
INPUT1
Input to INPUT 1 jack.
INPUT2
Input to INPUT 2 jack.
MI SHOE MIC
Microphone attached to Multi Interface
Shoe.
You can set the clipping-noise reduction
function for CH-1/CH-2.
B OFF
Disables the function.
ON
Enables the function.
b Note
• This function is available only when you set the
AUTO/MAN (CH-1/CH-2) switches to
“MAN.”
See page 84.
x
INT MIC SENS
You can set the audio recording sensitivity of
the internal microphone.
B NORMAL
Sensitivity generally used for professional-
use devices.
HIGH ( )
Sensitivity generally used for consumer-
use devices.
appears on the status check
screen.
x
INT MIC WIND
You can attenuate low tone input sound in the
internal microphone to reduce wind noise.
B OFF
Disables wind noise reduction.
ON ( )
Enables wind noise reduction.
appears on the status check screen.
b Note
• If the internal microphone is selected for both
CH-1 and CH-2 (CH-1: INT MIC, CH-2: INT
MIC), the sound that is output from the
headphones during recording and standby will
have weaker stereo effect than the sound that is
actually recorded.
x XLR AGC LINK
You can select either linked or separate AGC
(Auto Gain Control) of CH-1 and CH-2 when
using an external microphone.
B
SEPARATE
Separately applies the AGC for channels 1
and 2. Sound inputs from channels 1 and 2
will be recorded separately.
LINKED ( )
Links AGC (channels 1 and 2 are recorded
with linked AGC, like stereo).
appears on the status check screen.
b
Note
• Enabled when the AUTO/MAN switches for
both CH-1 and CH-2 are set to “AUTO,” and
LINE, MIC, or MIC+48V is selected on the
INPUT 1/INPUT 2 switches for both channels
(p. 82).
CH2 INPUT SELECT
AUDIO LIMIT
HEADPHONE OUT
INT MIC SET
XLR SET
A
(AUDIO SET) menu (continued)