Sony PVM-741, Operating Instructions Manual

Page: 26 / 36

Adjustment Using the Menus
26
FOCUS SETTING
FUNCTION BUTTON SETTING
When VECTOR is selected
POSITION Sets the position of the WFM/ALM/
VECTOR display. You can select from
among 1 to 4.
•
1 : Bottom left
• 2 : Bottom right
• 3 : Top right
• 4 : Top left
COLOR Selects the displayed line color from
white (W), red (R), green (G), blue (B)
and yellow (YL), when WFM is
selected.
INTENSITY Sets the brightness of the waveform, etc.
The larger the value, the brighter the
waveform.
ZOOM When ON is set, 0-20 IRE areas will be
zoomed when WFM is selected, or black
areas will be zoomed when VECTOR is
selected.
LINE SELECT Select ON to display the wave form of
the line assigned in LINE POSITION
below, when WFM is selected.
LINE POSITION Sets the line position when WFM is
selected.
When the numerical value is increased,
the line will move down; when
decreased, the line will move up.
TARGET Select 75 or 100. Switches the
vectorscope target between 75% and
100%.
Submenu Setting
0
OVER
(dB)
-10
-20
-30
-60
1 2
Audio level
Color target frame
Black
Magenta
Yellow
Bar I
Blue Green Cyan
Red
Bar Q
Channel number
(The channel number which is selected in
SDI AUDIO SETTING is displayed.)
Submenu Setting
FOCUS MODE Switches the focus mode.
•
STD : An image with sharpened edges
is displayed.
• COLOR : Displays the intensified
areas of images with color
selected in COLOR below.
• OFF: FOCUS MODE is deactivated.
COLOR Selects the displayed intensified color
from white (W), red (R), green (G), blue
(B), and yellow (YL).
FREQUENCY Sets the center frequency of the edge
sharpening signal.
You can select from L, M, MH, H.
RANGE Sets the amount by which the level of
edge sharpening may vary.
You can set from 1 to 3.
GAIN Sets the level of edge sharpening.
You can select from 0 to 100.
Submenu Setting
F1 BUTTON to F7
BUTTON Assigns the function to the function
buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, BLUE ONLY,
MONO, MARKER, I/P MODE, etc.
Factory setting
• F1 button : BRIGHTNESS
• F2 button : CONTRAST
• F3 button : CHROMA
• F4 button : SCAN
• F5 button : H/V DELAY
• F6 button : VOLUME
• F7 button : I/P MODE
F O C U S M O D E : xxx
C O L O R : xx
F R E Q U E N C Y: x
R A N G E : x
G A I N : x
USER CONFIG – FOCUS SETTING
F 1 B U T T O N : xxxx
F 2 B U T T O N : xxxx
F 3 B U T T O N : xxxx
F 4 B U T T O N : xxxx
F 5 B U T T O N : xxxx
F 6 B U T T O N : xxxx
F 7 B U T T O N : xxxx
USER CONFIG – FUNCTION BUTTON SETTING