Sony PMW-PZ1, Service Manual

Page: 67 / 78

5-12. IF-1227 Board
Note
• When removing/installing the main board assembly, place the unit on the conductive cushion
• The eject lever for SxS card must be retracted for the work in this section.
Preparation
1. Remove the top panel. (Refer to “5-2. Top Panel” )
2. Remove the front panel assembly. (Refer to “5-3. Front Panel Assembly” )
3. Remove the front chassis assembly. (Refer to “5-9. Front Chassis Assembly” )
4. Remove the main board assembly. (Refer to “5-11. Main Board Assembly” )
Procedure
1. Remove the four screws.
Note
When removing screws, fix the support (M3 x 19) with nippers or the like to prevent the support from turning.
2. Remove the HPR-56 board from the connector (CN201) on the IF-1227 board.
Note
Remove the HPR-56 board with the CPU board installed.
3. Remove the four supports (M3 x 19).
IF-1227 board
HPR-56 board
Supports (M3 x 19)
Supports (M3 x 19)
Conductive cushion
CN201
CN6401
PSW3 x 6
PSW3 x 6
4. Install the removed parts by reversing the steps of removal.
PMW-PZ1
5-23