Sony PCSA-CHG90, Operating Instructions Manual

Page: 61 / 87

17 GB
Installation
To attach the Camera Unit to a tripod
Attach a tripod to the screw hole used for attaching a tripod on the bottom of
the Camera Unit.
The tripod must be set up on a flat surface and tightened firmly by hand.
Use a tripod with screws of the following specifications.
Using the supplied ceiling brackets, wire rope and screws, and the attachment
materials (not supplied), you can attach the Camera Unit to a ceiling or on a
shelf, etc. in a high position.
When you install the camera, always install it on a level ceiling or shelf, etc. If
you have to install it on an incline, make sure that the inclination is within ± 15
degrees, so that the pan/tilt performance is guaranteed.
Installation of the camera using the tripod screws and screw holes should
not be done for installation on a ceiling or a shelf, etc. in a high position.
Installing the Camera Unit in a High Position
• When you attach the Camera Unit to a ceiling or shelf, etc. in a high
position, entrust the installation to an experienced contractor or installer.
• Attach the Camera Unit to a ceiling or shelf, etc. firmly, after making sure
the ceiling, shelf, etc. and the attachment materials (not including the
supplied accessories) are strong enough to bear a weight of 60 kg (132 lb
4 oz). If the ceiling or shelf, etc. is not strong enough, the Camera Unit may
fall and cause serious injury.
• Be sure to attach the supplied wire rope to prevent the Camera Unit from
falling.
• Check periodically, at least once a year, to ensure that the connection has
not loosened. If conditions warrant, make this periodic check more
frequently.
1
/
4
-20UNC
= 4.5 – 7 mm
= 0.18 – 0.27 inches
Caution
Caution