129
Ending the Connection
C
h
a
p
te
r 3:
B
a
si
c
C
o
nn
ect
ion
Ending the Connection
1
Press the DISCONNECT (
) button on the Remote Commander.
The message “Disconnect?” appears on the monitor screen.
2
Press the DISCONNECT (
) button on the Remote Commander again,
or press the
V
,
v
,
B
or
b
button on the Remote Commander to select “OK”,
then press the ENTER button.
The system is disconnected.
The power of the Communication System remains on even if the system is
disconnected.
To cancel disconnection of the system
Select “Cancel” with the
V
,
v
,
B
or
b
button on the Remote Commander, then
press the ENTER button.
To register the connected remote party in the Phone Book
You can easily register the remote party who has just disconnected.
If you set “Last Number Registration” to “On” on the Device Setup page of the
General setup menu, the message “Register this participant in the list?”
appears after a communication with an unregistered remote party is finished.
When you select “OK”, the List Edit menu appears.
If the “Last Number Registration” is set to “Off”, the message does not appear.
For “Last Number Registration” setting, see “General Setup Menu” on page
88.
Note
Note
