103
Restrictions on the Use of LAN2 (PCS-XG100/XG100S only)
C
h
a
p
te
r 2:
R
e
gi
s
tr
a
tio
n
an
d Se
tu
p
fo
r Sy
s
tem
A
d
m
in
is
tr
a
to
rs
Restrictions on the
Use of LAN2
(PCS-XG100/XG100S
only)
When you use two LAN connections, use
the
1 (LAN1) connector to connect to a
private network in your company and the
2 (LAN2) connector to connect to the
internet or locations outside of your
company.
The following functions of the system are
restricted when using the
2 (LAN2)
connector.
• When connecting the system to the internet
or locations outside of your company,
configure the following settings.
– When using only the
1 (LAN1)
connector, set “Web Access”, “Telnet
Access” and “SSH Access” to “Disabled”
on the Access Permit page (page 94) of the
Administrator setup menu.
– When using both the
1 (LAN1)
connector and the
2 (LAN2)
connector, use the
2 (LAN2) connector
to connect to the internet or outside
locations.
• The
2 (LAN2) connector cannot be used
on its own.
Items that cannot be set with LAN2
• NAT Mode
• Gatekeeper
• SNMP Mode
• SIP
• NTP
• Shared Phone Book
• AMX Device Discovery
• H.460
• DNS
• Streaming
• IPv6
• Web Access, Telnet Access, SSH Access
Item that can be set with either
LAN1 or LAN2
• PPPoE
Items to be set with LAN1 or LAN2
individually
• DHCP Mode
• IP Address
• Network Mask
• Gateway Address
• LAN Mode
Items to be set with LAN1 and LAN2
commonly
• Used Port Number (TCP, UDP)
• QoS
• TOS
• Auto Answer
• Reject Answer
Do not set the same subnet for the LAN1 and
LAN2 connections.
Notes
Note
