Sony PCS-1 - Video Conferencing Kit, Operating Instructions Manual, Page: 142 / 284

142
Conducting a Data Conference Using NetMeeting – T.120 Data Conference
Conducting a Data Conference Using
NetMeeting – T.120 Data Conference
Connecting the Communication Terminal to the computer with NetMeeting*
installed enables conduct of a data conference in compliance with the T.120
standard of the ITU-T Recommendation via the PCS-1/1P Video
Communication System only when it is connected over ISDN.
*
NetMeeting is a registered trademark of Microsoft Corporation.
• When the Communication Terminal is used for a multipoint videoconference, the
T.120 data conference is not available.
• When the PCS-1/1P Video Communication System is connected with a
videoconferencing system at the remote party via LAN, conduct the T.120 data
conference without using the PCS-1/1P.
To connect a computer
To connect a computer to the connector on the Communication
Terminal
Use a commercially available UTP cross cable (category 5) to connect the
LAN connector on the computer with the 100BASE-TX/10BASE-T connector
on the Communication Terminal.
Notes
ISDN
DC 19.5V
AUDIO OUT AUDIO IN AUX1– VIDEO IN–AUX2 CAMERA UNIT MIC
(PLUG IN POWER)
(MIXED)
AUX MAIN– MONITOR– SUB
VIDEO OUT
RGB OUT
IR OUT
100BASE-TX
10BASE-T
1 2
1 2
ISDN UNIT WHITE
BOARD
DSB
TERMINAL VISCA OUT
DC 19.5V
AUDIO OUT AUDIO IN AUX1– VIDEO IN–AUX2 CAMERA UNIT MIC
(PLUG IN POWER)
(MIXED)
AUX MAIN– MONITOR– SUB
VIDEO OUT
RGB OUT
IR OUT
100BASE-TX
10BASE-T
1 2
1 2
ISDN UNIT WHITE
BOARD
DSB
TERMINAL VISCA OUT
to 100BASE-TX/
10BASE-T
Computer
UTP cross cable
(not supplied)
to LAN
connector
PCSA-B768S
ISDN Unit
UTP cross cable
(not supplied)
to LAN
connector
to 100BASE-TX/
10BASE-T
Computer