NWZ-S763/S763BT/S764/S764BT/S765
7
Note:
Follow the disassembly procedure in the numerical order given.
2-2. CABINET (FRONT) BLOCK
cabinet (front) block
cabinet (front) block
panel (rear) block
panel (rear) block
Left side:
3
four claws
3
three claws
7
claw
2
Insert the jig in the gap between cabinet
(front) block and panel (rear) block.
Then slide it to arrow direction to remove
claws of cabinet (front) block.
2
Insert the jig in the gap between cabinet
(front) block and panel (rear) block.
Then slide it to arrow direction to remove
claws of cabinet (front) block.
– Rear bottom view –
– Front bottom view –
– Front bottom view –
JIG
When disassembling the set, use the following jig.
Part No. 9-913-402-33 Tool for Disassembly
8
cabinet (front) block
Right side:
knob (hold)
switch
4
Note 5:
When installing cabinet (front) block, the position
of switch and knob (hold) is set and installed.
Note 2:
Take care because the plate bends outside
if the cabinet (front) block is rotated.
Note 2:
Take care because the plate bends outside
if the cabinet (front) block is rotated.
5
adhesive sheet (chassis cover)
Note
3:
Remove taking care not to
damage the cabinet (front)
block.
6
adhesive sheet (cap)
Note
4:
Remove taking care not to
damage the cabinet (front)
block.
1
two screws (PTP1.4)
Note
1:
When you tighten two screws (PTP1.4),
tighten according to the following.
tightening tor
T
ue
1
m
