35
Installing the software onto your computer
Before installing the software
•
Make sure to close any virus-check software, as such software usually demands a large
amount of system resources.
•
Even if OpenMG Jukebox, SonicStage, SonicStage Premium, SonicStage Simple Burner,
or Net MD Simple Burner has been previously installed, install the software with the
supplied CD-ROM. The existing software may be overwritten by the new version or it
may co-exist with SonicStage depending on the version of your software. Follow the
instructions that appear in the window for the installation.
You will still be able to use music data registered by a previous software version even if
the previous version has been overwritten by or co-exists with new SonicStage Ver. 2.0.
As a precaution, we recommend that you back up your music data. To back up the data,
refer to [Backing Up My Library]
–
[Backing Up Data to a Disk] on SonicStage Help
.
1
Turn on your computer and start up Windows.
2
Insert the supplied CD-ROM into the CD drive of your computer.
The setup program starts up automatically and the installation window appears.
Depending on the region, a window may appear asking you to select your country. In
this case, follow the displayed instructions.
3
Click [Install SonicStage and MD Simple Burner] and then follow the
displayed instructions.
Read the instructions carefully.
Depending on your region, the buttons other than [Install SonicStage and MD Simple
Burner] may differ from those in the illustration above.
The installation may take 20 to 30 minutes, depending on your system environment.
Make sure to restart your computer only after the installation is completed.
Was the installation successful?
If any trouble occurs during the installation, see “Troubleshooting” (page 51).
Click [Install SonicStage and MD Simple
Burner]