Sony MVS-8000X SystemMVS-7000X System, User Manual

Page: 656 / 706

USO
RESTRITO
656
Tally Copy Settings (Tally Copy Menu)
Knob Parameter Adjustment Setting values
5 Input No
Tally input port
number
1 to 102
Ch
a
p
te
r 23
S
e
tu
p
Re
la
ti
n
g
to
Ro
u
te
r In
te
rfa
c
e
and
T
a
lly
(Ro
u
te
r/Ta
lly
)
DCU1: Generate tally with reference to signal input to
DCU1 port. Set the port number with the knob.
DCU2: Generate tally with reference to signal input to
DCU2 port. Set the port number with the knob.
5
Turn the knob to select the tally input port number.
6
Press [Execute].
This sets the settings made in steps 2 to 5 as the
settings for tally generation.
Tally Copy Settings (Tally
Copy Menu)
You can copy the tally information pertaining to a
particular source to a different source.
For settings relating to the tally copy function, use the
Router/Tally >Tally Copy menu. The settings are common
to the parallel and serial tallies.
To display the Tally Copy menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’
and HF5 ‘Tally Copy.’
The status area shows the tally copy status.
Modifying Tally Generation
1
In the Router/Tally >Tally Enable menu, press
[Modify].
The Modify menu appears.
2
With reference to steps
2
to
5
in the preceding section
“Making New Tally Generation Settings,” change the
parameters as required.
3
Press [Execute].
Deleting Tally Generation Settings
1
Using either of the following methods in the Router/
Tally >Tally Enable menu, select the tally generation
entry you want to delete.
•
Press directly on the list in the status area.
•
Press the arrow keys to scroll the reverse video
cursor.
2
Press [Delete].
Making New Tally Copy Settings
1
In the Router/Tally >Tally Copy menu, select [New].
The New menu appears.
2
Turn the knob to select the copy-from source.
When setting more than one tally copy, you can
specify the copy-from source start and end addresses.
Knob Parameter Adjustment Setting values
1 Copy From
(From) Copy-from source
start address 1 to 1024
2 Copy From
(To) Copy-from source
end address 1 to 1024
3
Specify the copy-to source address.
Knob Parameter Adjustment Setting values
3
Copy To
(From) Copy-to source
(start) address
1 to 1024
4 Copy To
(To) Copy-to source
(end) address 1 to 1024
4
Press [Execute].
This makes the tally copy setting according to the
specifications in steps
2
and
3
.
Modifying Tally Copy Settings
1
In the Router/Tally >Tally Copy menu, press
[Modify].
The Modify menu appears.
2
Use the knobs to select the copy source and copy
destination.