Sony MVS-8000X SystemMVS-7000X System, User Manual

Page: 344 / 706

USO
RESTRITO
344
Applying Special Effects (Other Effects)
Ch
a
p
te
r 11
DM
E
O
p
e
ra
ti
o
n
s
Applying Special Effects
(Other Effects)
Background Settings
Adds a color or inputs an external signal to the background
of the image.
Notes
Signal selection for this purpose is not supported on the
MVE-8000A.
Applying the Background effect
1
In the DME menu, select VF6 ‘Input/Output’ and HF1
‘Bkgd.’
The Bkgd menu appears.
2
Press [Bkgd], turning it on.
The Background effect is enabled. Only if Flat Color
is selected in the <Bkgd Fill> group, you can adjust the
parameters with the knobs.
3
Set the following parameters.
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
Selecting the signal to insert in the
background
When using the MVE-9000, you can select the signal to
insert in the background.
With [Bkgd] set on, use the following procedure.
1
In the <Bkgd Fill> group, select one of the following.
Flat Color: single color
Mix Color: mix color signal set in the Color Mix
menu (see page 302)
Ext Video: an external video signal input to the Ext IN
connector
Notes
• “Mix Color” or “Ext Video” can only be applied to
one of the background, flex shadow
(see page 296) ,
trail (see page 331) , and wind (see page 335) effects.
If you select “Mix Color” or “Ext Video” in one of
these settings, a selection of “Mix Color” or “Ext
Video” in any of the other effects is disabled, and
“Flat Color” is selected in its place.
•
When executing combining four channels of DME
images, “Mix Color” and “Ext Video” cannot be
selected.
2
Only if Flat Color is selected in step
1
, adjust the
following parameters.
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
Separate Sides Settings
Applies separate video signals and key signals to the front
and back of the image.
Applying the Separate Sides effect
1
In the DME menu, select VF6 ‘Input/Output’ and HF2
‘Video/Key.’
The Video/Key menu appears.
2
Press [Separate Side], turning it on.
The Separate Sides effect is enabled. If the video and
key signals currently being output to the monitor are
the front side, you can select the front signals. If they
are the back side, you can select the back signals.
Video and key signals are selected with the cross-point
control blocks of each M/E bank or the PGM/PST
bank.
Shaped Video Settings
For each of the front and back sides of the image, specifies
whether to handle input video from the switcher as shaped
video (key processed signals).
You can also make these settings for the output video.
Notes
•
When using an SDI interface, with the [PROC KEY] not
selected in the output destination buttons, then the
shaped video function is enabled.
•
When using the dedicated interface or SDI interface,
with [PROC KEY] selected in the output destination
buttons, since the input video signal to the first channel
is always set to the key processed signal on the switcher,
the shaped video setting is always on. For the second and