Sony MVS-6000, User Manual

Page: 265 / 400

265
Still Image Operations
Cha
p
te
r 7
F
ra
m
e Memor
y
Off: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) individually.
For more details, see “Pair mode” (page 257).
Note
In the Pair Recombination menu, the [Pair] operation is not possible.
4
Press the target FM selection button [FM1] or [FM2] (see page 261) to
select the FM operations apply to.
When [Pair] is On: Whichever of FM1 and FM2 you press, the pair is
selected.
When [Pair] is Off: One of the targets must be selected. However, in the
Clip >Play menu you can also select both FM1 and FM2.
Selecting a frame memory folder
Press a button in the frame memory folder selection area (see page 263) .
By pressing [More] to switch the display, you can select from a maximum of
12 folders.
Thumbnails of the files within the selected folder appear.
Capturing and Saving an Input Image
As the input material for the frame memory, you can use the signal selected on
the frame memory source bus. For this signal you can use video processing
(video levels or hue value adjustment) or masking.
Allocating a frame memory source bus signal to one of FM1 to FM8, then
carrying out a freeze captures a still image in the corresponding frame memory
output image, and saves it in temporary memory.
For a freeze, an image can be captured either as video frame (a “frame freeze”)
or a video field (“field freeze”).
Note
When the system is powered off, any freeze images written to temporary
memory are lost.
Freezing an image and writing it to memory
To freeze the signal selected as input material, and write it to memory, use the
following procedure.
1
In the Frame Memory menu, select VF1 ‘Still’ and HF2 ‘Freeze/Store.’