8
Operation and parameter setting on the PC with enSuite
Page 98 of
135
G a s Q u a l i t y A n a l y z e r
GasLab Q2
If the connection could not be made an error
message appears.This error may have
several causes, such as the device is turned
off or is still in the startup phase. The address
you entered was incorrect or hardware errors
occur.
See chapter
7.4.5
Figure 8.3: No connection was established
A scheduled automatic disconnection takes place upon recording a new parameterization. See
chapter 8.3.
The connection can also be interrupted by
other events such as
“Supply voltage
F
ailure” in the device or wire break. In
these
cases,
the
disconnection
is
displayed in a dialog box.
Figure 8.4: Connection has been interrupted
8.1.3 Readout and watch parameterization (device settings)
Read the parameterization out after each change.
Save each read out as a backup for emergencies separately. There is no
automatic safe function of the parameterization in enSuite
There must be an active data connection to the device (see 8.1.2) before the parameterization
can be readout from the Q2. You do not need a login for the read out. When connected select the
action
Read out parameterization
in the lower section of the navigation window or open the
context menu and select “
Read out paramet
erization”
Enter a name for the file in the
Save as
dialog.
The read parameterization is then stored
with this name. In the branch under
Devices - <Serial Number/Name> -
Parameterizations
.
Change the proposed name e.g. to
"Backup_YYYY-MM-DD" Using a date
always allows you to allocate the correct
backup).
Check the storage in the navigation window,
a file with the same name must exist now
Figure 8.5: Dialog
Save as
Figure 8.6: Example Saved Parameterization
