Chapter 12
Setup Menus
12-12
Chapter 12
Setup Menus
12-4 Items in the Extended Setup Menu
Menu items in the range 250 to 299, relating to the network parameters (MSW-M2000E/M2000EP)
Item number
Item name
Settings
250
MAX RATE
Set the maximum transfer rate to the network by the transmitting e-VTR.
Best effort :
Send data at the maximum possible transfer rate.
1 Mbps to 50 Mbps:
Limit the data transfer rate to the selected value.
251
NO RF TIME
Set the continuous playback time of a nonrecorded section when the material
transfer range is from the tape top to the tape end (transfer of the virtual file
&whole.mxf), or from the current position to the tape end (transfer of the virtual
file ¤t.mxf) to stop the transfer automatically when a nonrecorded section is
played back continuously for a specific length of time.
5 sec to 30 sec
253
E-MONI AUD
Select the output audio channel of e-monitor.
track 1/2 :
Audio track channels 1 and 2 are output.
track 3/4:
Audio track channels 3 and 4 are output.
track 5/6:
Audio track channels 5 and 6 are output.
track 7/8:
Audio track channels 7 and 8 are output.
255
MXF PRX DEST
Select the registration number of the destination server for MXF Proxy AV
transmission, using the control panel.
1 to 5:
Registration number of the server you registered in the Web window
254
MXF D10 DEST
Select the registration number of the destination server for MXF D10
transmission, using the control panel.
1 to 5:
Registration number of the server you registered in the Web window
252
NET REGEN
Specify whether to enable the timecode (LTC) on the source cassette in the
trasmistting VTR to be recorded via a network as-is to the cassette in the
receiving VTR.
off :
The recorded timecode is regenerated by the timecode generator during
recording of video/audio signals transferred through the network.
on:
The timecode generator locks to the timecode of the transmitting VTR and the
timecode on the source tape is copied as-is during recording of video/audio
signals transferred through the network.
Note
A cassette tape is set to the condition specified with this menu item when a file is
defined on the tape for the first time. Once the condition is determined for a tape,
file definition/recording on the tape will be executed in the same condition
regardless of this item 252 setting. To change the condition for the cassette, it is
necessary to remove all the files from the tape and set to the new condition.
256
HTTP TR DUR
Set the duration of the MXF file to be sent to an HTTP server.
20 sec to 180 sec
(select from 20, 40, 60, 90, 120, 150 and 180 seconds)