36
List of Menus
List of Menus
The menu items are in the following categories.
A:proc (process)
B:mode
C: setup (tx-rx, tx-rx (cm), sdi_to_asi, asi_to_sdi,
sdti-cp_to_asi, asi_to_sdti-cp)
E:link_mng
L:network
M:setup-msb
N:maintenance
P:save
R:recall
S:osd
T:status
U:log
Menu items not included in the categories
listed at left
help (RS232C/telnet)
info (RS232C/telnet)
remote1 “stop” “play” “rec” “ff” “rew” “cueup
{hhmmssff}”
“standby_on” “standby_off”
“status” “tc”
remote2 “stop” “play” “rec” “ff” “rew” “cueup
{hhmmssff}”
“standby_on” “standby_off”
“status” “tc”
snmp*** “init” “sys” “host” “comm” “trap”
For details of the snmp menu, see the section “SNMP
Commands” (page 90).
In the following tables, the factory default settings are
enclosed in boxes.
The following symbols are also used.
*: Not supported by Versions 1.01 to 1.30.
**: Available when the MSBA-20IP is installed.
A:proc (process) menu
This is used as a setting value execution command.
B:mode menu
This is used as a operating mode selection command.
Item number
Category
Item
Function
A
proc
start
Checks the consistency of setting values, and if there is no problem
carries out the setting change.
If there is an inconsistency, returns the command number of the
related setting.
analyse
Checks the consistency of setting values, and if there is no problem
returns OK.
If there is an inconsistency, returns the command number of the
related setting.
Item number
Category
Item
Function
B
mode
tx-rx
Bidirectional encoder/decoder mode (sdi_to_asi/asi_to_sdi)
tx-rx (cm)
Bidirectional endoder/decoder mode, communication mode
sdi_to_asi
SDI input encoder mode
asi_to_sdi
SDI output decoder mode
sdti-cp_to_asi
SDTI-CP input encoder mode
asi_to_sdti-cp
SDTI-CP output decoder mode
