Sony MKS-6550, User Manual

Page: 124 / 454

USO
RESTRITO
124
DME Wipe Pattern Operations in the Flexi Pad
No. Parameter Adjustment
1 W Border width
2 L Luminance
3 S Saturation
4 H Hue
No. Parameter Adjustment
1 H Horizontal position
2 V Vertical position
3 H (R) Relative movement in the horizontal
direction
Ch
a
p
te
r 6
DM
E
W
ip
e
s
You can also select two channels by pressing the buttons
simultaneously.
Notes
The [2ND CH] button cannot be selected on the MVS-
3000.
Selecting the DME Wipe Pattern
The operation of selecting the DME wipe pattern in the
Flexi Pad is the same as the operation of selecting a wipe
pattern
(
1
p. 108) , except for pressing the [DME WIPE]
button to select DME wipe snapshot mode.
Note, however, that the pattern numbers for DME wipe
patterns have four digits
(
1
p. 381) .
DME wipe pattern edge setting buttons
BDR (border): Applies a border to the DME wipe pattern.
SOFT BDR (soft border): Softens the applied border.
You can adjust the parameters selected with these buttons
using the adjustment knobs, when the button is lit green.
When border is selected
When soft border is selected
Editing the DME Wipe Pattern
By pressing the [EDIT ENBL] button to switch the
memory recall section to editing mode, you can edit the
selected DME wipe pattern.
To exit from the editing mode, press the [EDIT ENBL]
button again, or press the [EXIT] button.
The operation of the following buttons is the same as when
editing a wipe pattern.
•
[EXIT] button
•
[PTN LIMT], [LIMT SET] buttons
•
[NORM], [NORM/REV], [REV] buttons
•
[KNOB 1/2] button
For details about each button operation,
1 “Editing the
Wipe Pattern” (p. 109) .
Channel selection buttons
1ST CH (channel 1): Selects channel 1.
2ND CH (channel 2): Selects channel 2.
Parameter group [1/2]
No. Parameter Adjustment
1 W Border width
2 I Border inner softness
Parameter group [2/2]
No. Parameter Adjustment
1 L Luminance
2 S Saturation
3 H Hue
Buttons for positioning the DME wipe
pattern
POS (positioner): Adjusts the position of the DME wipe
pattern.
CNTR (center): Returns the DME wipe pattern position
to the center.
When you press the [POS] button, the alphanumeric
display first shows the name of the parameter, “H” or “V,”
and then the value of the parameter.
When the [POS] button is lit green, you can adjust the
position of the pattern with the adjustment knobs.