USO
RESTRITO
Overview / Basic Wipe Setting Operations
101
Ch
a
p
te
r 5
W
ip
e
s
Wipes
Chapter
5
Overview
A wipe is a transition from the current video stream to a
new video stream, using a wipe pattern.
Changing the background by means of a wipe is referred to
as a “background wipe,” and inserting or deleting a key
with a wipe is termed a “key wipe.”
There are two types of wipe: those that can be selected in
a common transition, and those that can be selected in an
independent key transition.
Note that the available modifiers may depend on the
pattern you are using
Specifying the wipe direction (Direction)
Specify the direction of the wipe effect.
Normal
Wipe in the normal direction.
Basic Wipe Setting
Operations
Reverse
Wipe in the opposite direction of
the normal direction.
You carry out wipe setting operations using the Wipe
menu for each of the switcher banks.
This section describes an example on the M/E-1 bank.
For details about wipe settings for independent key
transitions,
“Basic Wipe Setting Operations for
Independent Key Transitions” (p. 105)
Wipe Pattern Selection
1
Open the M/E-1 >Wipe >Main Pattern menu (1151).
For details about wipe patterns,
2
Press the button to select the desired pattern.
The pattern appears on the screen.
Setting Wipe Modifiers
You can apply various modifiers to the wipe pattern:
setting the wipe direction, pattern position, etc.
Normal/reverse
The wipe direction alternates between normal and reverse
after each transition.
To specify the wipe direction in a menu
1
Open the M/E-1 >Wipe >Edge/Direction menu
(1154).
2
In the <Direction> group, select the wipe direction.
To specify the wipe direction with a button in the
transition control block
In the transition control block of each switcher bank, press
the following direction selection buttons.
NORM:
Normal
NORM/REV:
Normal/reverse
REV:
Reverse
Modifying the wipe pattern edge (Edge)
You can apply a border to the pattern or soften the edges.
