model name [MHC-GTR88]
[4-165-654-
71
(1)] GB
40
GB
filename[D:\shared_Chinmeng\NORMAN-PDF only\GB\GB080ADD.fm]
masterpage:Left
Troubleshooting
Should you encounter a problem with
your system, do the following:
1
Make sure the power cord and
speaker cords are correctly and
firmly connected.
2
Find your problem in the checklist
below, and take the indicated
corrective action.
If the problem persists after doing all of
the above, contact your nearest Sony
dealer.
Note that if service personnel changes
some parts during repair, these parts
may be retained.
General
The display starts flashing as soon as
you plug in the power cord even
though you have not turned on the
system.
• Press DISPLAY once while the system
is turned off. The demonstration
disappears.
The clock or timer setting is canceled.
• The power cord is disconnected or a
power failure occurred. Redo “Setting
the clock” (page 17). If you have set the
timer, redo “Using the timer” (page 37).
“– –:– –” appears in the display.
• The clock is not set. Set the clock
(page 17).
• A power failure has occurred. Set the
clock (page 17) and timer settings
(page 37) again.
There is no sound.
• Turn MASTER VOLUME clockwise
(or press repeatedly on the
remote).
• The headphones are connected to the
PHONES jack.
• Check the speaker connections
(page 12).
• There is no audio output during
Recording Timer.
There is no microphone sound.
• Turn MASTER VOLUME clockwise
(or press repeatedly on the
remote) or turn MIC LEVEL clockwise
to adjust the microphone volume.
• Make sure the microphone is connected
to the MIC jack correctly.
Additional Information
When the
"/1
indicator flashes
Immediately unplug the power cord,
and check the following items.
• If your system has a voltage selector,
is the voltage selector set to the
correct voltage?
• Are you using only the supplied
speakers?
• Are the + and – speaker cords short-
circuited?
• Is anything blocking the ventilation
holes of the unit?
After checking the above items and
fixing any problems, plug in the power
cord again and turn on the system. If
the
"/1
indicator still flashes, or if the
cause of the problem cannot be found
even after checking all the above
items, consult your nearest Sony
dealer.
