model name [MHC-GN1300D]
[4-132-091-
14
(2)] GB
87
GB
Ad
dit
ion
al I
n
fo
rmatio
n
filename[D:\NORM'S JOB\SONY HA\SO0163\MHC-GN1300D_PMRF
01\4132091142_GB\GB120INF.fm]
masterpage:Right
There is no microphone sound.
• Press repeatedly (or turn
MASTER VOLUME on the unit
clockwise) or turn MIC 1 LEVEL or
MIC 2 LEVEL on the unit clockwise to
adjust the microphone volume.
• Make sure the microphone is connected
to the MIC 1 or MIC 2 jack correctly.
• Make sure the microphone is turned on.
• Press MUTING on the unit if
“MUTING” appears in the display.
There is severe hum or noise.
• A TV or VCR is placed too close to the
unit. Move the unit away from the TV or
VCR.
• Move the unit away from the source of
noise.
• Connect the unit to a different wall
outlet.
• Install a noise filter (commercially
available) to the power cord.
The timer does not function.
• Check the timer setting and set the
correct time (page 78).
• Cancel the Sleep Timer function
• You cannot select the Play Timer and
the Recording Timer at the same time.
The remote does not function.
• Remove the obstacles between the
remote and the unit.
• Move the remote closer to the unit.
• Point the remote at the unit’s sensor.
• Replace the batteries (R6/size AA).
• Move the unit away from the
fluorescent light.
The color irregularity on a TV screen
persists.
• Turn off the TV at once, then turn it on
after 15 to 30 minutes. If the color
irregularity still persists, place the
speakers farther away from the TV.
There is acoustic feedback.
• Reduce the volume.
• Move the microphone away from the
speakers or change the direction of the
microphone.
The sound from the component
connected to the TV/SAT AUDIO IN
L/R jacks is distorted.
• If “TV” appears in the display when you
press TV/SAT on the unit, switch to
“SAT” function (see “To switch
between the “TV” and “SAT” function”
on page 84).
THEATRE SYNC function does not
work.
• If the distance between the TV and this
unit is too far, this function may not
work. Install the unit near the TV.
Meter
Meter pointer does not move.
• “POINTER” is set to “OFF” in the
OPTIONS menu. Select other settings.
• Meter mode is set to “METER OFF”.
Press METER MODE on the unit
repeatedly to select other modes.
• The headphones are connected to the
PHONES jack. Disconnect the
headphones.
Meter display is turned off.
• “POINTER” and “BACKLIGHT” are
set to “OFF” in the OPTIONS menu.
Select other settings.
• Meter mode is set to “METER OFF”.
Press METER MODE on the unit
repeatedly to select other modes.
Meter display is flashing.
• “POINTER” and “BACKLIGHT” are
set to “FLASH” in the OPTIONS menu.
Select other settings.
• Meter mode is set to “EXCITE 1” or
“EXCITE 2”. Press METER MODE on
the unit repeatedly to select other
modes.
Continued
l