Sony MG40 Series, Command Reference Manual

Page: 106 / 140

4-18
(E)
MG40 Series
4-4. Setup Commands

Output resolution
Th is function is used to set and acquire the output resolution.
A value lower than the input resolution cannot be set for the output resolution.
When STD2 serves as the Area of use setting, the value in parentheses ( ) is used as the output resolution
setting.
Th
e scale diff ers between JPN/STD1 and STD2. When the setting has been established for an area with a
diff erent scale, the setting values related to the output resolution will be restored to the factory statuses.
Set
Setup
mode
Ethernet CC-Link
The command sets the output resolution.
Command format
OPR Designated axis =<Polarity><Resolution>
<Polarity>

: Plus

: Minus
<Resolution>
(Input resolution
Output
resolution)
1 : 0.1 μm (0.000005”)
(Factory setting:
Same as for the
input resolution
setting)
2 : 0.5 μm (0.00001”)

3 : 1 μm (0.00005”)
4 : 5 μm (0.0001”)
5 : 10 μm (0.0005”)

0.00002" when the input resolution is 0.5 μm
Return format Execution results
Target Designated axis
Save setting values Setting values saved.
Examples of use Transmission :
OPR[00A]=

3
Return : OK000
Compatible command
Designated axis SDR=<Polarity><Resolution>
Acquire
Setup
mode
Ethernet CC-Link
Measurement
mode
The command acquires the output resolution.
Command format
OPR Designated axis ?
Return format OPR Designated axis =<Polarity><Resolution>
<Polarity>

: Plus

: Minus
<Resolution> 1 : 0.1 μm (0.000005”)
2 : 0.5 μm (0.00001”)

3 : 1 μm (0.00005”)
4 : 5 μm (0.0001”)
5 : 10 μm (0.0005”)

0.00002" when the input resolution is 0.5 μm
Target Designated axis
Examples of use Transmission :
OPR[00A]?
Return : OPR[00A]=

3
Compatible command Designated axis SDR?