Sony MCC3000MT, Service Manual

Page: 43 / 194

2-7. Main Board Assembly (for CAMERA B)
Preparation
1. Remove the top cover. (Refer to “2-2. Top Cover” . )
2. Remove the main board assembly (for CAMERA A). (Refer to “2-6. Main Board Assembly (for CAMERA A)” . )
Procedure
1. Open the clamp.
2. Disconnect the three fine-wire coaxial cables from the three connectors (CN100, CN101 and CN102) on the
DPR-340 board.
3. Remove the two flat clamps.
4. Disconnect the flexible flat cable from the connector (CN200) on the AVP-18 board.
5. Disconnect the harness from the connector (CN701) on the CN-3550 board.
AVP-18 board
CN200
Flat clamps
Clamp
Flexible flat cable
CN-3550 board
CN701
Harness
CN100
CN101
CN102
Fine-wire coaxial cables
DPR-340 board
Note
When installing, arrange the harness as shown in the figure.
6. Disconnect the flexible flat cable from the connector (CN803) on the AVP-18 board.
7. Disconnect the harness from the connector (CN900) on the AVP-18 board.
8. Disconnect the harness from the connector (CN1400) on the DPR-340 board.
9. Disconnect the two coaxial cables from the two connectors (CN1301, CN1700) on the AVP-18 board.
10. Open the two clamps.
MCC-3000MT
2-11