Sony MCC3000MT, Instructions For Use Manual

Page: 41 / 56

Setup Menu List 41
Me
n
u
Co
nf
igur
at
ion
a
nd
Det
a
ile
d
Set
tings
VIDEO SET menu
VIDEO SET
Menu items Subitems and setting values Contents
Setup
Setting 7.5% setup
for the composite
signal
On
Off Set whether to add 7.5% setup to the output signal from the
VIDEO OUT connector when a format of NTSC is selected
(The factory-default values will differ depending on the unit
model.) (Invalid when a format of PAL is selected).
Down
Converter
Selecting the
operation mode of
the down converter
SQ
(Squeeze)
LB (Letterbox)
EC (Edge Crop)
Set the output mode (aspect) for SD output from the VIDEO
OUT connector.
Squeeze: To horizontally reduce a 16:9 picture to output a 4:3
picture
Letterbox: To mask the upper and lower areas of a 4:3 picture
to display a 16:9 picture in the center of the screen
Edge Crop: To cut the both sides of a 16:9 picture to output a
4:3 picture
OTHERS menu
OTHERS
Menu items Subitems and setting values Contents
All Reset
Resetting to the
factory status
Execute
Cancel Select “Execute” to reset the unit to the factory status.
The White Shading setting will not be reset.
Note
When you execute reset, wait until “Done” appears to indicate
that resetting is complete.
Genlock
Setting the genlock
phase
H Advance
0H / 90H
Set the V phase for genlock.
90H: When the reference signal is SD, the HD SDI output
phase is advanced 90H. When the reference signal is HD,
the HD SDI output phase is synchronized and the SD
output phase is delayed 90H.
0H: The HD SDI and SD output phases are synchronized to
the reference signal.
Country
Setting the area for
use
NTSC Area
PAL Area
Select the color system for the area where you will use the
unit.
Note
The picture may fail to appear on your video monitor if this
item is set incorrectly.
Version
Showing the
version of this unit
Vx.xx The current software version of the unit is displayed.