Picture Profiles
36
Sho
o
ting
Matrix
Adjusting the color phase
over the entire area with
matrix operations
Setting
On
/ Off
Set to “On” to activate the color phase adjustment
function with matrix operations for the entire
picture.
Select
Type1
/ Type2 / Type3 / Type4
Select one of the four types of built-in preset
matrixes.
Level
–99 to +99 (
±0
)
Adjust the color saturation for the entire picture
area.
Phase
–99 to +99 (
±0
)
Adjust the hue for the entire picture area.
R-G, R-B, G-R, G-B, B-R, B-G
–99 to +99 (
±0
)
Finely adjust the color phase for the entire picture
area by independently setting each of the factors.
Detail
Adjusting the details to be
applied to the picture
Setting
On
/ Off
Set to “On” to apply the details to the picture
signal.
Level
–99 to +99 (
±0
)
Adjust the detail level.
Frequency
–99 to +99 (
±0
)
Set the center frequency of the details.
Setting the center frequency higher decreases the
details, and setting it lower increases the details.
Crispening
–99 to +99 (
±0
)
Adjust the noise-suppression level.
When you set it to a higher level, less noise may be
seen, as fine elements of details are deleted leaving
only high-level elements.
When you set it to a lower level, fine elements are
applied while increasing noise.
H/V Ratio
–99 to +99 (
±0
)
Adjust the horizontal-to-vertical ratio of detail
elements.
A higher value makes the vertical elements
increased with respect to the horizontal elements.
White Limiter
–99 to +99 (
±0
)
Limit the white details.
Black Limiter
–99 to +99 (
±0
)
Limit the black details.
V DTL Creation
Y
/ G / G+R / NAM
Select the source signal to generate vertical details
from among Y, NAM (G or R whichever is higher),
G, and G+R.
Knee APT Level
–99 to +99 (
±0
)
Adjust the knee aperture level (level of details to be
applied to the sections above the knee point).
PICTURE PROFILE SET
Items
Subitems and setting values
Contents
Summary of Contents for MCC3000MT
Page 56: ...Sony Corporation ...
