Sony LSPX-W1, Operating Instructions Manual

Page: 16 / 91

16
Adjusting the Projection Image
• When adjusting the lens, each time you press
the LENS button on the unit, the lens
adjustment function switches as follows.
Depending on the installation location of the
unit, you may not be able to control it with the
remote control. In this case, point the remote
control at the remote control detector of the
unit.
1
After connecting the AC power cord to
the unit, plug the AC power cord into
a wall outlet.
The unit goes into standby mode.
2
Press the ? / 1 (ON/STANDBY) button
to turn on the unit.
The top cover opens.
The LED indicator lights in white.
Tip
The LED indicator does not light when
“Illumination” is set to “Off” on the Installation
menu.
3
Press the PICTURE POSITION
button that matches the projection
size.
* Approximate adjustment value. When
the setting is overwritten in “Picture
Position” of the Screen
menu
(page 39), it cannot be returned to the
default setting.
To perform further adjustment or change
the image size by using the zoom
function, follow the steps
3 to 6 .
4
Press the PATTERN button to display
the
lens adjustment window (test
pattern) .
To return to the previous screen, press
the PATTERN button again.
Note
Image size
(for
maximum
zoom)
Installation
distance
(from a
projection
surface to
the rear of
the unit)
Destination
for
adjustment *
147- to
132-inch 11 to 17 cm
(4.3 to 6.7
inches) PICTURE
POSITION
Custom 1
132- to
121-inch 6 to 11 cm
(2.4 to 4.3
inches) PICTURE
POSITION
Custom 2
121- to
113-inch 3 to 6 cm
(1.2 to 2.4
inches) PICTURE
POSITION
Custom 3
113- to
106-inch 0 to 3 cm
(0 to 1.2
inches) Default
setting