Sony LMT-300, User Manual

Page: 33 / 71

26
Projector
C
h
ap
te
r 1
U
s
e
r Gu
id
e
To restore the projector output (open the
“douser”), tap
Menu , tap Projector , tap
Projector Control and then, in the
DOUSER block, tap the alternate action ON /OFF button.
The projector output is restored, the auditorium screen is
illuminated, the control button label changes to OFF and
the button status indicator is dark.
Audio Muting
The AUDIO MUTING control function in the
PROJECTOR CONTROL screen causes the sound output
from the Auditorium Unit to be silenced. In film based
systems this may be coupled to the DOUSER but in Digital
Cinema the image presentation has been decoupled from
the sound presentation to make the system more versatile
for non-cinema presentations.
When you set the AUDIO MUTING to ON the sound to
the auditorium is silenced. However, this only applies to
the sound portion of the presentation. The image portion of
the presentation continues and must be Doused using the
DOUSER control.
Audio Muting ON (Silence)
The Audio Muting control is an alternate action button
whose current state is indicated by the status label and a
status indicator in the
OFF/ON button. When the control’s
status indicator is out (label shows OFF) the audio output
is enabled and the current presentation sound is available
in the auditorium.
To silence the audio output, tap Menu ,
tap Projector , tap Projector Control and
then, in the AUDIO MUTING block, tap
the alternate action
OFF /ON button. The sound output is
silenced, the auditorium is silenced, and the control button
label changes to ON and its status indicator is lit (see inset
in illustration). The presentation continues to run.
Audio Muting OFF (Sound ON)
Audio Muting is activated by an alternate action control
button whose current state is indicated by the status
indicator located in the
ON/OFF button. When the
indicator is illuminated (label shows ON) the sound output
is silenced.
To restore the sound output, tap Menu ,
tap Projector , tap Projector Control and
then, in the AUDIO MUTING block, tap
the alternate action
ON /OFF button. The sound output is
restored, the auditorium sound is restored, the control
button label changes to OFF and the button status indicator
is dark.
Change Projector Function
Changing the Current FUNCTION selection (F1 to F20) is
done using Change FUNCTION on the PROJECTOR
CONTROL screen. Functions can be used to recall stored
settings which affect the projector setup. Each
FUNCTION configuration is set using the SRX
Controller
1
application and is set to optimize the on-screen
presentation. In addition, a limited number of settings
associated with a specific FUNCTION can be configured
using the
FUNCTION SETUP screen (see page 27) .
The configurations are stored and available on a pop-up
accessed from the Projector Control screen. These are
single button FUNCTION selections.
Note: A FUNCTION can be associated with a CPL and,
indirectly, an SPL using the SMS Controller. In this way
the same configuration is recalled whenever the associated
Content Element is presented.
MANUALLY SELECTING A FUNCTION WILL
CHANGE THE PROJECTOR SETTINGS UNTIL A
NEW FUNTION IS SELECTED.
Manual FUNCTION selection is made from a pop-up that
appears when you tap Change FUNCTION on the
PROJECTOR CONTROL screen. To access the
PROJECTOR CONTROL screen, tap
Menu and then tap
Projector Control . The Current FUNCTION selection is
indicated in the Function group.
AUDIO MUTING
OFF/ON
1.The SRX Controller exercises direct control over the
projector and therefore should not be used at the same time
the Projectionist Terminal or SMS Controller is in opera-
tion.
Change Function
Current Function