20
GB
To improve tuner reception
When tuner reception is poor, set CD player
power off by CD power manage function.
CD power is factory set to on.
1
Press FUNCTION (or FU or – on
the remote) repeatedly until “CD” appears.
2
Press
?/1
to turn off the system.
3
Press
?/1
while holding
x
.
“CD POWER OFF” appears.
To set CD power on
Repeat the procedure above and “CD POWER
ON” appears.
Notes
• When “CD POWER OFF” is selected, disc access
time is increased.
• You cannot change the setting in Power Saving
Mode (page 33).
To change the AM tuning interval
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding TUNER
ENTER, press
?/1
to turn the system back on.
When you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode (page 33).
Tips
• The preset stations are retained for half a day even if
you disconnect the power cord or if a power failure
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 19).
1
Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2
Press TUNING MODE repeatedly until
“PRESET” appears.
3
Press /– (or /– on
the remote) repeatedly to select the
desired preset station.
To select the desired preset
number using the number buttons
on the remote
Press number buttons on the remote instead of
performing step 3. To enter preset number 10 or
higher, press >10 and the corresponding number
buttons. To enter 0, press 10/0.
Listening to the radio
