KDL-40R355B 15
SECTION 3 - REPAIR INFORMATION
16. Press
or
to select characters and then to move to the next
space until Model Name is complete.
NOTE
: Make sure to include dash in Model Name.
>>
Self diagnosis history
>>
Wide Band Tuning
>>
LVDS Spectrum (%)
29
Tuning System
Auto
Status Digital RF Information
Off
Off
Low of HPD
5
UART Selection
Factory
TEST RESET
[</>]Set [Home] Exit
Service Mode
NS4S400DND1101
Status Information
<[
]>
<[
]>
<[
]>
<[
]>
<[
]>
<[
]>
Off
Panel Selection
SERIAL NUMBER EDIT
MODEL NAME EDIT
KDL-40R355B
2000001
CAUTION: The Model Name can only be selected once. Be sure
to verify the information is correct before saving the changes.
17.
When the complete Model Name displays, press
.
18.
On the confirmation screen, press to select
YES
and then
.
Input Data Correct?
Yes
No
Selected text displays in black
19. Press
POWER
to exit
Service Mode
.
REMOVING THE PANEL ORNAMENTAL
1.
Locate and remove 1 screw, then slide the Panel Ornamental from
the left side to detach it as shown.
REMOVING THE H BOARD
2.
Disconnect the connector from the H Board as shown.
3. Lift the H Board from the left side and refer to the illustration to make
sure its been detached, then lift it to remove.
