KDL-32EX655/40EX655/46EX655 40
SECTION 5 - UPDATES AND ADJUSTMENTS
SETTING WHITE BALANCE ADJUSTMENTS
White Balance adjustment data is located on the Digital Service Menu.
11. Press
2
to move to 006 WB Category.
VPC
SERVICE
006
000
WB
R_DRV 128
12.
To change the data value of the
R_DRV
, press
3
to increase the
value or
6
to decrease the value.
NOTE: The data value must be set between the range 1 to 255.
13. Press
1
to move to the next item (
001 G_DRV)
.
14.
To change the data value, press
3
to increase the value or
6
to
decrease the value.
15.
Repeat steps 6 and 7 for each of the following items:
002 B_DRV
003 R_BKG
004 G_BKG
005 B_BKG
16.
To save the changes, press
MUTING
then press
0
.
17.
Exit service mode by turning the TV power off.
RESETTING THE TV TO FACTORY CONDITION
Use the following instructions to restore the User Adjustments and Channel
Memory settings to the preset factory conditions.
1.
Turn the TV On by pressing
POWER
, then wait approximately
40 to 60 seconds.
2.
While holding down the on the Remote Commander, press the
POWER
button on the side of the TV.
3.
The set restarts and displays the Initial Setup screen. This may
take several minutes.
RESETTING THE TV TO FACTORY CONDITION USING
SERVICE MODE
1.
Take the TV out of deep Standby mode by pressing
POWER
to
turn on the TV.
2. Press
POWER
to turn the TV back off.
3.
Press the following buttons on the Remote Commander within a
second of each other:
DISPLAY
Channel
5
Volume
+
POWER
4.
If necessary, press
JUMP
or
OPTIONS
to go to DIGITAL menu.
5.
Press the following buttons on the Remote Commander within a
second of each other:
Press
8
MUTING
0
.
SERVICE changes to green RST.
RST executes the command and displays EXE.
EXE-RST displays green, then red indicating the TV is writing the
data.
