Adjustment
31
Selecting the memory number/adjusting the screen by recalling the
stored conditions
By selecting the memory number, you can change the image position and
size on the screen to the conditions stored to that memory number.
When you want to store the image position and size data to the specified
memory number after adjustment, you should select the memory number
before the adjustment, performing the following steps.
1
Establish communication with the ICU controller (page 21) and
display the MAIN MENU.
2
Press the
v
or
V
button to select SIGNAL CONTROL and press the
ENTER button.
The SIGNAL CONTROL menu appears.
S W I T C H E R C O N T R O L
S I G N A L C O N T R O L
G E O M E T R Y C O N T R O L
M O N I T O R C O N T R O L
S C R E E N C O N T R O L
S C R E E N U N I T C O N T R O L
O T H E R C O N T R O L
* * * * * * M A I N M E N U * * * * * *
* * * S I G N A L C O N T R O L * * *
I N P U T - 1
I N P U T - 2
3
Press the
v
or
V
button to select the input (INPUT-1 or INPUT-2) and
press ENTER button.
The SIG-CTRL menu appears.
* * S I G - C T R L < I N P U T - 1 > * *
C O L O R :
3 2
H U E : 3 2
S H A R P N E S S : 7
G E O M E T R Y M E M N O . 1
M O N I T O R M E M N O . 1
f H : 1 5 . 7 5 K H z
f V : 6 0 . 0 0 H z
S I G - T Y P E : N T S C
I N P U T - 1 : C O M P O S I T E
4
Select the memory number.
Press the
v
or
V
button to select GEOMETRY MEM NO. and press
the
B
or
b
button to select the memory number 0 – 31 to which the
desired conditions are stored.
* * S I G - C T R L < I N P U T - 1 > * *
C O L O R :
3 2
H U E : 3 2
S H A R P N E S S : 7
G E O M E T R Y M E M N O .
1
M O N I T O R M E M N O . 1
f H : 1 5 . 7 5 K H z
f V : 6 0 . 0 0 H z
S I G - T Y P E : N T S C
I N P U T - 1 : C O M P O S I T E
5
Press the ENTER button.
The screen is adjusted to the stored conditions.
To return to the MAIN MENU
Press the MENU button.
Memory number
