Ad
mi
ni
st
ra
ti
n
g
th
e Ca
mer
a
Saving the Camera Position and Action — Preset position Menu
49
With this item, you can select whether you restart or stop
the tour after it has stopped by manual pan, tilt or zoom
operation or by camera movement to the preset position
triggered by an alarm.
On:
Specify the wait time before the tour restarts,
between 5 and 600 seconds. The tour restarts
automatically after the specified time has elapsed.
Off:
The tour does not restart.
Tour A to Tour E
Configure Tour A to Tour E respectively.
Each tour setting consists of 5 items:
On/Off
,
Effective
period
,
Stay time
,
Speed
and
Sequence
.
On:
The tour operates.
Off:
The tour does not operate.
Effective period
Select the period during which the tour in activated.
Always:
The tour can be activated any time.
Schedule:
The tour is activated according to the
schedule you have set.
Click
Schedule
, and the menu for the effective
period is displayed. (“Setting the Schedule —
Schedule Menu” on page 63.)
Note
You cannot set tours if the effective periods overlap each
other.
Stay time
Type a period of time during which the camera is to stay
at each preset position, between
1
and
3600
seconds.
Speed
Select the speed of camera movement between
1
and
23,
or
Fastest
from the drop-down list. The camera moves
faster with a higher number setting. The fastest speed is
obtained with
Fastest
.
Sequence
Set the sequence of the tour.
The preset positions saved using the Position tab are
displayed in the drop-down list at the bottom.
Select the preset position from the drop-down list, then
click
Add
. The selected preset position is added in the
Sequence
list. Repeat this procedure to specify the
preset positions in sequence.
If you specified an unnecessary preset position, click to
select it in the list and click then
Delete
.
To change the order in the list, click to select the preset
position and then click
Up
or
Down
.
Note
The tour cannot be set to
On
if no preset position is
added in the
Sequence
list.
OK/Cancel
