54
Registering Local Information
Network Quality Status
Displays the reason for the failure of the load
and stress test, when it has failed.
Packet Loss (%)
Displays the measurement results of packet
loss during transmission and reception.
The packet loss values of audio, and video
up to the maximum bandwidth are
displayed.
jitter
Displays the measurements results of jitter
during transmission and reception.
The jitter values of audio, and video up to the
maximum bandwidth are displayed.
Result of Network Quality
Measurement (Duplex) (Page 4/4)
The result of the network quality
measurement in both directions between this
unit and the remote party is shown on this
page. The displayed items are the same as
those on Page 3/4.
The following menus appear when you
select “LAN” on the Setup menu. Select the
desired menu.
For details about the settings, consult your
network administrator.
General (Page 1/2)
DHCP Mode
Allows you to select whether the Dynamic
Host Configuration Protocol (DHCP) server
is enabled.
Auto:
The IP address, network mask, and
gateway and DNS addresses are
automatically assigned. You should
confirm the assigned IP address in the
launcher menu or the Machine
Information menu after the LAN
connection is established.
Off:
Disables the DHCP server. In this case,
enter an IP address, network mask,
gateway and DNS addresses.
Host Name
Enter your host name (up to 30 characters).
IP address
Enter the IP address.
Network Mask
Enter the network mask.
Gateway Address
Audio
2M
2.5M
3M
4M
Packet Loss (%)
Encode Decode
Jitter (ms)
Encode Decode
5M
6M
7M
8M
Other
Packet Loss (%)
Encode Decode
Jitter (ms)
Encode Decode
Administrator Setup
2005.12.28 12:34
End
3/4
Page:
Resout of Network Quality Measurement
Simplex
Network Quality Status
LAN Setup Menu
LAN Setup
2005.12.28 12:34
Previous
General
Gatekeeper
SNMP
PPPoE
NAT/Port
QoS
TOS
LAN Setup
General
Cancel
Save
2005.12.28 12:34
Host Name
Auto
local host
.
.
.
.
.
.
.
.
.
DHCP Mode
Network Mask
IP Address
DNS Address
Gateway Address
1/2
Page:
