27
Turning the System On/Off
C
h
apt
er
1:
In
st
al
la
tio
n
an
d Pr
e
p
a
ra
tio
n
To cancel setting the system to standby
Select “Cancel” with the
B
or
b
button on the Remote Commander, then press
the PUSH ENTER button in step 2 above.
To release the standby mode
Press any button on the Remote Commander.
To specify the standby time
Specify the time that you want the system to remain on before entering into
standby mode (max. 99 minutes) by selecting “Device Setup” on the General
Setup menu, and then setting “Standby Time”. If you do not want the system
to enter the standby mode, set “Standby Mode” to “Off”.
For the “Standby Time” and “Standby Mode” settings, see “General Setup
Menu” on page 47.
1
Press the
?
/
1
(power) switch on the Communication Terminal.
The message “Power Off?” appears on the monitor screen and the POWER/
STANDBY indicator on the Communication Terminal flashes.
2
Press the
?
/
1
(power) switch again within five seconds.
The power of the system is turned off.
3
Turn off the power of other equipment.
• Set the power switch on the Communication Terminal off when the system will not
be used for an extended period. While the power switch is off, you cannot receive a
call from a remote party.
• Disconnect the power cord from the AC outlet after the power of the system has been
completely turned off.
• If the Communication Terminal is left with its power cord disconnected from the AC
outlet for approximately 10 days or more, the date and time setting will be cleared. In
this case, set the date and time again using “Clock Set” in the General Setup menu.
Before adjusting the volume on the TV monitor, set the volume on the
Communication Terminal to the appropriate position.
1
Press the /– buttons on the Remote Commander to set the
volume level on the adjustment bar displayed on the screen to the middle
position.
Turning Off
Notes
Adjusting the Volume on the TV Monitor
